SGM Giotto spot 1200 Operation & User’s Manual

13, 13 D Giotto spot rel.1.00 EFEENN I Appendix 2.2-RS232 connection For this connection, use good quality screened coax cable (RG58 50Ohms) to avoid problems with signal transmission and faulty fixture operation. Connectors must always be 5-pin XLRs. Refer to the diagram for wiring.…

20, SGM Giotto spot 1200 20 Giotto spot rel.1.00 3.13 - Display brightness Operators can select one of the brightness levels available for the Giotto display, which can be standard or very low. This option is intended for theatre and television use, where excessive brightness can be troublesome. To change display brightn…

5, 5 D Giotto spot rel.1.00 EFEENN I Appendix Main features Lamp Giotto Spots use a Philips MSR 1200SA 6500°K discharge lamp, without doubt the ideal light source for this type of fixture, as it combines reliability and long life (approximately 500 ) with astonishing luminous power. Effects - …

25, 25 D Giotto spot rel.1.00 EFEENN I Appendix 8.0-CHANNEL SHUTTER/ STROBE CH - 8 The Shutter/Strobe is controlled by Channel 8. The mechanism which enables the strobe effect to be generated is the same as that used for dimming the light beam, however it's also possible to control the light&…

19, 19 D Giotto spot rel.1.00 EFEENN I Appendix 3.8 - Fixture operating time meter This function allows to see for how many hours the fixture has been operating. This meter cannot be reset. To see for how many hours the fixture has been used, proceed as follows: 1. Connect Giotto Spot…

24, 24 Giotto spot rel.1.00 7.0- GOBO CHANNEL - CH 7 Gobo selection is controlled by Channel 7. The gobo group comprises two independent wheels, each with four images and a blank position. The gobos are interchangeable and superimposing the two wheels enables 25 different combinations to …