Lexmark MS310 Series Service Manual

131, Inserting a cable into the horizontal top contact connector 1 When installing the cable, check the locking actuator to ensure it is in the unlocked position. The tabs on the ends of the actuator are vertical when the actuator is unlocked. 2 Insert the cable with the contacts on the cab…

68, 202 paper jams 202 paper jam messages Error code Description Action 202.01 Exit sensor is covered during warm up. Go to “Sensor (fuser exit) jam service check” on page 70. 202.03 Media did not reach the fuser exit sensor. 202.05 Fuser exit sensor covered too long by the curre…

85, Lexmark MS310 Series Error code Description Action 31.40 Toner cartridge smart chip error 1 Make sure that the toner cartridge is properly installed. 2 Check if the toner cartridge is supported. Replace with a supported toner cartridge if necessary. 3 If the problem remains, go to “Toner cartridge smart chip…

198, c Bring the cable in front of the two cable holders near the ACM shaft. 4514-220, -230 Repair information 198 …

48, Miscellaneous messages Complex page, some data may not have printed [39] Try one or more of the following: • From the printer control panel, press to continue printing. A data loss may occur. • From the printer control panel, press to cancel the print job. • Install additional printer …

11, Notices and safety information Laser notices Laser notice The printer is certified in the U.S. to conform to the requirements of DHHS 21 CFR, Chapter I, Subchapter J for Class I (1) laser products, and elsewhere is certified as a Class I laser product conforming to the requirements of IEC …