Olivetti d-Copia 42 Operation Manual

23, 24 (2) When toner runs out… When toner runs out, a message telling you to add toner will be displayed on the touch panel. Refer to the Instruction Handbook for your copier and replace the toner cartridge. (3) When paper jams… When paper jams, a message informing you of the paper…

19, 20 1 Print Option Status Setting to “ON” allows you to print the status of the optional network board when making a status test print. “ON” or “OFF” can be selected by using the “–” key or “+” key. * By default, “OFF” is selected. To exit the setting, press …

16, Olivetti d-Copia 42 17 3 Form Feed Time Out It is possible to set the maximum amount of time that the printer will wait to receive data from the computer. If the printer does not receive any data from the computer within the amount of time specified here, printing will be cancelled. Press the “–” or �…

22, 23 (1) When you think there is trouble… If you experience trouble while you are using this unit as a printer, refer to the table below. If trouble persists, contact your service representa- tive, an authorized service or the place of purchase. * For more detailed information regarding general…

12, 13 5. Operation (1) Issuing printing commands Carry out the following procedure in order to issue printing commands from your computer and print out with this unit. Turn the main switch ON ( | ). * The basic copier screen will appear on the touch panel and, once warm up is complete, “RE…

18, 19 4 5 6 7 The currently registered IP address, Subnet Mask and Gateway address will all be displayed. To change an address, press the appropriate “CHANGE” key to display the corresponding setting screen. * To change the network management code, proceed to step 6. Note: It is …